Cisco Nexus 5500 Series - Interface Mgmt

181
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter I Commands
interface mgmt
interface mgmt
To enter the management interface configuration mode, use the interface mgmt command.
interface mgmt mgmt-intf-num
Syntax Description
Command Default None
Command Modes Global configuration mode
Command History
Examples This example shows how to enter the management interface configuration mode:
switch# configure terminal
switch(config)# interface mgmt 0
switch(config-if)#
Related Commands
mgmt-intf-num Management interface number. The interface number is 0.
Release Modification
5.2(1)N1(1) This command was introduced.
Command Description
show interface mgmt Displays information about the management interface.
cdp enable Enables the Cisco Discovery Protocol (CDP) on an interface.
description (interface) Adds a description to an interface configuration.
duplex Configures the duplex mode for an interface.
lldp (interface) Enables the reception or transmission of Link Layer Discovery Protocol
(LLDP) packets on an interface.
rate-limit cpu
direction
Configures the packet per second (PPS) rate limit for an interface.
snmp trap link-status Enables Simple Network Management Protocol (SNMP) link trap generation
on an interface.
speed Configures the transmit and receive speed for an interface.
vrf member Adds an interface to a virtual routing and forwarding (VRF) instance.