Cisco Nexus 5500 Series - Show Cdp Traffic

1276
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show cdp traffic
show cdp traffic
To display the Cisco Discovery Protocol (CDP) traffic statistics, use the show cdp traffic command.
show cdp traffic interface {ethernet slot/[QSFP-module/]port | mgmt mgmt-num}}
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display the CDP traffic statistics for an Ethernet interface:
switch# show cdp traffic interface ethernet 1/29
----------------------------------------
Traffic statistics for Ethernet1/29
Input Statistics:
Total Packets: 3203
Valid CDP Packets: 3203
CDP v1 Packets: 0
CDP v2 Packets: 3203
Invalid CDP Packets: 0
Unsupported Version: 0
Checksum Errors: 0
Malformed Packets: 0
Output Statistics:
Total Packets: 3203
CDP v1 Packets: 0
CDP v2 Packets: 3203
Send Errors: 0
switch#
This example shows how to display CDP traffic statistics for a management interface:
interface Displays CDP traffic statistics for an interface, Ethernet or management.
ethernet
slot/[QSFP-module/]port
Displays CDP traffic statistics for an Ethernet interface. The slot number
is from 1 to 255. The QSFP-module number is from 1 to 4. The port
number is from 1 to 128.
Note The QSFP-module number applies only to the QSFP+ Generic
Expansion Module (GEM).
mgmt mgmt-num Displays CDP traffic statistics for a management interface. The
management interface number is 0.
Release Modification
6.0(2)N1(1) Support for the QSFP+ GEM was added.
5.2(1)N1(1) This command was introduced.