1454
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter V Commands
vtp version
vtp version
To configure the administrative domain to a VLAN Trunking Protocol (VTP) version, use the vtp
version command. To revert to the default version, use the no form of this command.
vtp version version
no vtp version
Syntax Description
Command Default Version 1 enabled
Version 2 disabled
Command Modes Global configuration mode
Command History
Usage Guidelines Before you use this command, you must enable VTP on the switch by using the feature vtp command.
If you enable VTP, you must configure either version 1 or version 2. If you are using VTP in a Token
Ring environment, you must use version 2.
Examples This example shows how to enable VTP version 2 for Token Ring VLANs:
switch(config)# vtp version 2
switch(config)#
Related Commands
version VTP version. The range is from 1 to 2.
Release Modification
5.2(1)N1(1) This command we introduced.
Command Description
feature vtp Enables VTP on the switch.
show vtp status Displays VTP information.
To Previous Page
Loading...
