Cisco Nexus 5500 Series - Show Interface Ethernet

1286
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show interface ethernet
show interface ethernet
To display information about the interface configuration, use the show interface ethernet command.
show interface ethernet slot/[QSFP-module/]port[.subintf-port-no] [brief | counters | description
| status | switchport]
Syntax Description
Command Default Displays all information for the interface.
Command Modes EXEC mode
Command History
Examples This example shows how to display the detailed configuration of the specified interface:
switch# show interface ethernet 1/1
Ethernet1/1 is up
Dedicated Interface
Hardware: 40000 Ethernet, address: c84c.753d.5b78 (bia c84c.753d.5b78)
MTU 1500 bytes, BW 40000000 Kbit, DLY 10 usec
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA
Port mode is access
auto-duplex, 40 Gb/s
Beacon is turned off
slot/[QSFP-module/]port Ethernet interface slot number and port number. The slot number is from
1 to 255. The QSFP-module number is from 1 to 4. The port number is
from 1 to 128.
Note The QSFP-module number applies only to the QSFP+ Generic
Expansion Module (GEM).
. (Optional) Specifies the subinterface separator.
Note This keyword applies to Layer 3 interfaces.
subintf-port-no (Optional) Port number for the subinterface. The range is from 1 to 48.
Note This argument applies to Layer 3 interfaces.
brief (Optional) Displays brief information about the interfaces.
counters (Optional) Displays information about the counters configured on an
interface.
description (Optional) Displays the description of an interface configuration.
status (Optional) Displays the operational state of the interface.
switchport (Optional) Displays the switchport information of an interface.
Release Modification
6.0(2)N1(1) Support for the QSFP+ GEM was added.
5.2(1)N1(1) This command was introduced.