Cisco Nexus 5500 Series - Page 293

1287
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show interface ethernet
Input flow-control is off, output flow-control is off
Switchport monitor is off
EtherType is 0x8100
Last link flapped never
Last clearing of "show interface" counters never
0 interface resets
30 seconds input rate 0 bits/sec, 0 packets/sec
30 seconds output rate 0 bits/sec, 0 packets/sec
Load-Interval #2: 5 minute (300 seconds)
input rate 0 bps, 0 pps; output rate 0 bps, 0 pps
RX
0 unicast packets 0 multicast packets 0 broadcast packets
0 input packets 0 bytes
0 jumbo packets 0 storm suppression bytes
0 runts 0 giants 0 CRC 0 no buffer
0 input error 0 short frame 0 overrun 0 underrun 0 ignored
0 watchdog 0 bad etype drop 0 bad proto drop 0 if down drop
0 input with dribble 0 input discard
0 Rx pause
TX
0 unicast packets 0 multicast packets 0 broadcast packets
0 output packets 0 bytes
0 jumbo packets
0 output errors 0 collision 0 deferred 0 late collision
0 lost carrier 0 no carrier 0 babble 0 output discard
0 Tx pause
switch#
This example shows how to display the counters configured on a specified interface:
switch# show interface ethernet 1/1 counters
--------------------------------------------------------------------------------
Port InOctets InUcastPkts
--------------------------------------------------------------------------------
Eth1/1 0 0
--------------------------------------------------------------------------------
Port InMcastPkts InBcastPkts
--------------------------------------------------------------------------------
Eth1/1 0 0
--------------------------------------------------------------------------------
Port OutOctets OutUcastPkts
--------------------------------------------------------------------------------
Eth1/1 0 0
--------------------------------------------------------------------------------
Port OutMcastPkts OutBcastPkts
--------------------------------------------------------------------------------
Eth1/1 0 0
switch#
This example shows how to display the detailed configuration information of a specified subinterface:
switch# show interface ethernet 1/5.2
Ethernet1/5.2 is up
Hardware: 1000/10000 Ethernet, address: 0005.73a6.1dbc (bia 0005.73a6.1d6c)
Description: Eth 1/5.2 subinterfaces
Internet Address is 192.0.2.3/24
MTU 1500 bytes, BW 1500 Kbit, DLY 2000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation 802.1Q Virtual LAN, Vlan ID 100
EtherType is 0x8100