Cisco Nexus 5500 Series - Switchport Trunk Native Vlan

1257
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter S Commands
switchport trunk native vlan
switchport trunk native vlan
To configure the native VLAN ID for the virtual Ethernet interface, use the switchport trunk native
vlan command. To remove the native VLAN ID from the virtual Ethernet interface, use the no form of
this command.
switchport trunk native vlan vlan_ID
no switchport trunk native vlan
Syntax Description
Command Default None
Command Modes Interface configuration mode
Virtual Ethernet interface configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to set VLAN 3 as the native trunk port:
switch# configure terminal
switch(config)# interface vethernet 1
switch(config-if)# switchport trunk native vlan 3
switch(config-if)#
Related Commands
vlan_ID VLAN ID of the native VLAN when this port is in trunking mode. The
range is from 1 to 4094.
Release Modification
5.2(1)N1(1) This command was introduced.
Command Description
interface vethernet Configures a virtual Ethernet interface.
show running-config Displays the running system configuration information.