Cisco Nexus 5500 Series - Show Interface Transceiver

1307
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show interface transceiver
show interface transceiver
To display the information about the transceivers connected to a specific interface, use the show
interface transceiver command.
show interface ethernet slot/[QSFP-module/]port transceiver [details]
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Usage Guidelines You can use the show interface transceiver command only for physical interfaces.
Examples This example shows how to display the transceivers connected to a specified Ethernet interface:
switch# show interface ethernet 1/1 transceiver
Ethernet1/1
transceiver is present
type is SFP-H10GB-CU1M
name is CISCO-MOLEX
part number is 74752-9044
revision is 07
serial number is MOC14081360
nominal bitrate is 10300 MBit/sec
Link length supported for copper is 1 m
cisco id is --
cisco extended id number is 4
switch#
ethernet
slot/[QSFP-module/]port
Displays information about an Ethernet interface slot number and port
number. The slot number is from 1 to 255. The QSFP-module number is
from 1 to 4. The port number is from 1 to 128.
Note The QSFP-module number applies only to the QSFP+ Generic
Expansion Module (GEM).
details (Optional) Displays detailed information about the transceivers on an
interface.
Release Modification
6.0(2)N1(1) Support for the QSFP+ GEM was added.
5.2(1)N1(1) This command was introduced.