Cisco Nexus 5500 Series - Mvr Vlan

1119
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter M Commands
mvr vlan
mvr vlan
To configure a Multicast VLAN Registration (MVR) VLAN for an interface, use the mvr vlan
command. To remove the MVR VLAN from an interface, use the no form of this command.
mvr vlan vlan_ID
no mvr vlan vlan_ID
Syntax Description
Command Default None
Command Modes Interface configuration mode
Virtual Ethernet interface configuration mode
Command History
Usage Guidelines You can use this command on the following interfaces:
• Ethernet interface
• Virtual Ethernet interface
Before you use a virtual Ethernet interface, you must enable the Cisco Virtual Machine Fabric Extender
(VM-FEX) on the switch by using the feature vmfex command.
This command does not require a license.
Examples This example shows how to configure an MVR VLAN for an interface:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# mvr vlan 1
switch(config-if)#
Related Commands
vlan_ID MVR VLAN ID. The range is from 1 to 4094.
Release Modification
5.2(1)N1(1) This command was introduced.
Command Description
feature vmfex Enables VM-FEX on the switch.
interface vethernet Configures a virtual Ethernet interface on the switch.
show mvr Displays information about MVRs.
show running-config Displays the running system configuration information.