Cisco Nexus 5500 Series - Feature Lacp

156
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter F Commands
feature lacp
feature lacp
To enable the Link Aggregation Control Protocol (LACP), which bundles a number of physical ports
together to form a single logical channel, use the feature lacp command. To disable LACP on the switch,
use the no form of this command.
feature lacp
no feature lacp
Syntax Description This command has no arguments or keywords.
Command Default LACP is disabled.
Command Modes Global configuration mode
Command History
Usage Guidelines You must remove all the LACP configuration parameters from all EtherChannels on the switch before
you can disable LACP.
Even after you enable LACP globally, you do not have to run LACP on all EtherChannels on the switch.
You enable LACP on each channel mode using the channel-group mode command.
Examples This example shows how to enable LACP EtherChannels on the switch:
switch(config)# feature lacp
Related Commands
Release Modification
5.2(1)N1(1) This command was introduced.
Command Description
show lacp Displays information on LACP.
show feature Displays whether or not LACP is enabled on the switch.