Cisco Nexus 5500 Series - capability (virtual Ethernet interface)

18
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter C Commands
capability (virtual Ethernet interface)
capability (virtual Ethernet interface)
To set a profile capability for a virtual Ethernet interface, use the capability command. To remove the
profile capability of an interface, use the no form of this command.
profile capability iscsi-multipath
no profile capability iscsi-multipath
Syntax Description
Command Default None
Command Modes Virtual Ethernet interface configuration mode
Command History
Examples This example shows how to set the profile capability for a specific virtual Ethernet interface:
switch# configure terminal
switch(config)# interface vethernet 1
switch(config-if)# capability iscsi-multipath
switch(config-if)#
Related Commands
iscsi-multipath Configure an iSCSI multipath profile.
Release Modification
5.2(1)N1(1) This command was introduced.
Command Description
interface vethernet Configures a virtual Ethernet interface.
show interface
vethernet
Displays the specified virtual Ethernet interface, attributes, and status.
show running-config
interface
Displays the running configuration of an interface.