Cisco Nexus 5500 Series - Page 265

1259
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter S Commands
system private-vlan fex trunk
system private-vlan fex trunk
To configure a PVLAN FEX trunk on port, use the system private-vlan fex trunk command. To remove
the PVLAN FEX trunk ports, use the no form of this command.
system private-vlan fex trunk
no system private-vlan fex trunk
Caution You must disable all the FEX Isolated trunk ports before configuring PVLANs on the FEX trunk ports.
If the FEX Isolated trunk ports and the FEX trunk ports are both enabled, unwanted traffic might occur.
Syntax Description This command has no arguments or keywords.
Command Default None
Command Modes Interface configuration mode
Command History
Examples This example shows how to configure PVLAN over a FEX trunk port:
switch# configure terminal
switch(config-if)# System private-vlan fex trunk
switch(config-if)# copy running-config startup-config
Related Commands
Release Modification
5.2(1)N1(1) This command was introduced.
Command Description
feature private-vlan Enables private VLANs.