Cisco Nexus 5500 Series - Page 300

1294
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show interface mgmt
show interface mgmt
To display the configuration information for a management interface, use the show interface mgmt
command.
show interface mgmt intf-num [brief | capabilities | counters [detailed [all] | errors [snmp]] |
description | status]
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display the configuration information of the management interface:
switch# show interface mgmt 0
mgmt0 is up
Hardware: GigabitEthernet, address: 0005.9b74.a6c1 (bia 0005.9b74.a6c1)
Internet Address is 192.0.2.174/21
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA
full-duplex, 1000 Mb/s
EtherType is 0x0000
1 minute input rate 11336 bits/sec, 9 packets/sec
1 minute output rate 2248 bits/sec, 3 packets/sec
Rx
22722587 input packets 7487592 unicast packets 7082728 multicast packets
intf-num Management interface number. The value is 0.
brief (Optional) Displays a summary of the configuration information for the
management interface.
capabilities (Optional) Displays the interface capabilities information.
counters (Optional) Displays information about the management interface counters.
detailed (Optional) Displays detailed information of only the nonzero interface
counters.
all (Optional) Displays all nonzero interface counters.
errors (Optional) Displays the interface error counters, such as receive or transmit
error counters.
snmp (Optional) Displays the Simple Network Management Protocol (SNMP)
MIB values for the nonzero interface counters.
description (Optional) Displays the interface description.
status (Optional) Displays the interface line status.
Release Modification
5.2(1)N1(1) This command was introduced.