Cisco Nexus 5500 Series - Page 302

1296
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show interface port-channel
show interface port-channel
To display the information about an EtherChannel interface configuration, use the show interface
port-channel command.
show interface port-channel number[.subinterface-number] [brief | counters | description |
status]
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display the configuration information of a specified EtherChannel interface:
switch# show interface port-channel 21
port-channel21 is up
Hardware: Port-Channel, address: 000d.ece7.df72 (bia 000d.ece7.df72)
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA
Port mode is trunk
full-duplex, 10 Gb/s
Beacon is turned off
Input flow-control is on, output flow-control is on
Switchport monitor is off
Members in this channel: Eth2/3
Last clearing of "show interface" counters never
30 seconds input rate 0 bits/sec, 0 packets/sec
30 seconds output rate 352 bits/sec, 0 packets/sec
Load-Interval #2: 5 minute (300 seconds)
input rate 0 bps, 0 pps; output rate 368 bps, 0 pps
RX
0 unicast packets 0 multicast packets 0 broadcast packets
number EtherChannel number. The range is from 1 to 4096.
.subinterface-number (Optional) Port-channel subinterface configuration. Use the EtherChannel
number followed by a dot (.) indicator and the subinterface number. The
format is:
portchannel-number.subinterface-number
counters (Optional) Displays information about the counters configured on the
EtherChannel interface.
description (Optional) Displays the description of the EtherChannel interface
configuration.
status (Optional) Displays the operational state of the EtherChannel interface.
Release Modification
5.2(1)N1(1) This command was introduced.