Cisco Nexus 5500 Series - Page 328

1322
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show mac address-table count
show mac address-table count
To display the number of entries currently in the MAC address table, use the show mac address-table
count command.
show mac address-table count [address EEEE.EEEE.EEEE] [dynamic | static] [interface
{ethernet slot/[QSFP-module/]port | port-channel number}] [vlan vlan-id]
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display the number of dynamic entries currently in the MAC address table:
switch# show mac address-table count dynamic
MAC Entries for all vlans:
Total MAC Addresses in Use: 7
switch#
address EEEE.EEEE.EEEE (Optional) Displays a count of the MAC address table entries for a
specific address.
dynamic (Optional) Displays a count of the dynamic MAC addresses.
static (Optional) Displays a count of the static MAC addresses.
interface (Optional) Specifies the interface. The interface can be Ethernet or
EtherChannel.
ethernet
slot/[QSFP-module/]port
(Optional) Specifies the Ethernet interface slot number and port
number. The slot number is from 1 to 255. The QSFP-module number
is from 1 to 4. The port number is from 1 to 128.
Note The QSFP-module number applies only to the QSFP+
Generic Expansion Module (GEM).
port-channel number (Optional) Specifies the EtherChannel interface. The EtherChannel
number is from 1 to 4096.
vlan vlan-id (Optional) Displays information for a specific VLAN. The range is
from 1 to 4094.
Release Modification
6.0(2)N1(1) Support for the QSFP+ GEM was added.
5.2(1)N1(1) This command was introduced.