Cisco Nexus 5500 Series - Page 404

1398
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show startup-config flexlink
show startup-config flexlink
To display the startup configuration for Flex Links, use the show startup-config flexlink command.
show startup-config flexlink [all]
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display the startup configuration for Flex Links:
switch# show startup-config flexlink
!Command: show startup-config flexlink
!Time: Wed Jan 30 00:37:27 2013
!Startup config saved at: Sun Jan 27 03:40:28 2013
version 6.0(2)N1(1)
feature flexlink
logging level Flexlink 5
interface port-channel300
switchport backup interface port-channel301 preemption mode forced
interface port-channel500
switchport backup interface port-channel501 preemption delay 36
switchport backup interface port-channel501 multicast fast-convergence
interface port-channel502
switchport backup interface port-channel503
interface port-channel504
switchport backup interface Ethernet2/1
interface Ethernet1/2
switchport backup interface Ethernet1/1
interface Ethernet1/20
switchport backup interface Ethernet1/21
interface Ethernet2/2
switchport backup interface port-channel507 preemption mode forced
all (Optional) Displays information about Flex Links including default
settings.
Release Modification
5.2(1)N1(1) This command was introduced.