Cisco Nexus 5500 Series - Page 447

1441
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter V Commands
vmware (virtual Ethernet interface)
vmware (virtual Ethernet interface)
To configure a VMware policy on a virtual Ethernet interface, use the vmware command. To revert to
the defaults, use the no form of this command.
vmware dvport DVPort_number [dvswitch uuid "DVSwitch_uuid"]
no vmware dvport DVPort_number [dvswitch uuid "DVSwitch_uuid"]
Syntax Description
Command Default None
Command Modes Virtual Ethernet interface configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure a VMware policy on a specific virtual Ethernet interface:
switch# configure terminal
switch(config)# interface vethernet 1
switch(config-if)# vmware dvport 3 dvswitch uuid "nexusDVswitch"
switch(config-if)#
Related Commands
dvport Configures distributed virtual (DV) port mapping.
DVPort_number Distributed virtual (DV) port number. The range is from 0 to 4294967294.
dvswitch uuid (Optional) Configures the DV switch Universally Unique Identifier (UUID).
DVSwitch_uuid DV switch UUID in quotes. The ID can be 48 alphanumeric characters.
Release Modification
5.2(1)N1(1) This command we introduced.
Command Description
show interface
vethernet
Displays information about the virtual Ethernet interface configuration.
show running-config
interface
Displays the running system configuration information for an interface.