Figure 14: Attaching Cable Management Side Frames Together
Alignment pin fits into alignment hole on
power-supply frame
3I/O-module cable management frame1
M4 x 14 mm screw secures the frames together as
a cable management frame assembly
4Power-supply cable management frame2
b) Secure the two frames together by using an M4 x 14 mm screw and tighten to 11.5 to 15 in-lb (1.3 to 1.7 N·m) of
torque.
c) Repeat Steps 1a and 1b to attach the other power-supply cable management frame to the other I/O cable management
frame.
Step 2 Attach the two cable management frame assemblies to the chassis as follows:
Cisco Nexus 7710 Switch Site Preparation and Hardware Installation Guide
35OL-30452-01.
Installing the Chassis
Installing Cable Management Frames on a Chassis
To Next Page
Loading...
