Cisco Nexus 9348GC-FXP NX-OS User Manual

CHAPTER 3
Installing the Switch Chassis
•
Safety, page 17
•
Installation Options with Racks and Cabinets, page 18
•
Airflow Considerations, page 18
•
Installation Guidelines, page 18
•
Unpacking and Inspecting the Switch, page 19
•
Installing the Switch, page 20
•
Installing the Switch into a Two-post Rack, page 24
•
Grounding the Chassis, page 27
•
Starting the Switch, page 29
Safety
Before you install, operate, or service the switch, see the Regulatory, Compliance, and Safety Information for
the Cisco Nexus 3000 and 9000 Series for important Safety Information.
Statement 1071—Warning Definition
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Use the statement number provided at the end of each warning
to locate its translation in the translated safety warnings that accompanied this device.
SAVE THESE INSTRUCTIONS
Warning
Cisco Nexus 9348GC-FXP NX-OS Mode Hardware Installation Guide
17

Cisco Nexus 9348GC-FXP NX-OS Specifications

General

Product Model	Nexus 9348GC-FXP
Switch Type	Fixed
Form Factor	1 RU
Jumbo Frame Support	Yes
Jumbo Frame Size	9216 bytes
Operating System	Cisco NX-OS
Memory	16 GB
Flash Memory	16 GB
VLANs	4096
Operating Temperature	32 to 104°F (0 to 40°C)
Storage Temperature	-40 to 158°F (-40 to 70°C)
Humidity	5 to 95% noncondensing
Layer Support	Layer 2, Layer 3
Power Supply	Dual hot-swappable power supplies
Buffer Size	12 MB
Input Voltage	100-240 VAC
Dimensions (H x W x D)	1.72 x 17.3 x 18.1 in (4.4 x 43.9 x 46.0 cm)
DC Power Input	-40 to -72 VDC
Ports	48 x 1/10/25-Gbps and 4 x 40/100-Gbps