•
After initialization, the switch chassis Status (labeled as STA or STS) LED is green.
Step 5
Verify that the system software has booted and the switch has initialized without error messages.
Step 6
Complete the worksheets provided in Site Preparation and Maintenance Records for future reference.
Note
A setup utility automatically launches the first time that you access the switch and guides you through the basic
configuration. For instructions on how to configure the switch and check module connectivity, see the appropriate Cisco
Nexus configuration guide.
Cisco Nexus 9348GC-FXP NX-OS Mode Hardware Installation Guide
30
Installing the Switch Chassis
Starting the Switch
To Next Page
Loading...
