Figure 14.4: This page allows you to configure the SNMP properties, such as the community settings, and
identify the IP address for the trap messages to be sent to.
STP—The Spanning Tree Management page. This management page allows you to enable or disable
STP on the specific switch ports, modify various Spanning Tree parameters, and configure STP.
Among other things, you can set the path cost, priority, and port fast mode. For an example, see
Figure 14.5.
•
Figure 14.5: This page gives you more details and options for configuring STP.
CDP—The CDP Management page. This page lists all the devices that have Cisco Discovery
Protocol (CDP) enabled. You can browse them, access them by Telnet, and retrieve further details on
the selected device. Figure 14.6 shows an example.
•
278
To Next Page
Loading...
