Cisco RV132W - Page 20

Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide 18
3
When the Internet Connection Type is RFC2684 Bridged (DHCP or
Static mode)
In the DSL Settings for the ATM transfer mode, enter the following information:
Size Enter the size of bytes. (Range 576 - 1500, Default
1500).
Transfer Mode AT M
Multiplexing Defines the way in which different
protocols are handled within a DSL
virtual circuit. You can choose
between a Logical Link Control (LLC)
encapsulation and Virtual Channel (VC)
multiplexing.
QoS Type Select the DSL Quality of Service
(QoS): Unspecified Bit Rate (UBR),
Constant Bit Rate (CBR), Variable Bit
Rate - real time (VBR-rt), Variable Bit
Rate - non-real time (VBR-nrt). CBR
provides the best guarantee of low
latency; UBR provides none, but is
typically used for most broadband
data services.
Pcr Rate - When the QoS is set to CBR,
VBR-rt, or VBR-nrt, enter the Peak Cell
Rate (PCR) in cells per second.
Scr Rate - When the QoS is set to
VBR-nrt or VBR-rt, enter the Sustained
Cell Rate (SCR) in cells per second.
Auto Detect Check Enable to enable or Disable to
disable automatic detection of the VPI
and VCI values that identify your line to
the ATM network.