Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide 54
3
STEP 3 Enter the following information:
STEP 4 Click Save.
To edit the settings of a VLAN, select the VLAN and click Edit. To delete a selected
VLAN, click Delete. Click Save to apply changes.
Configuring Static DHCP
You can configure your router to assign a specific IP address to a client device
with a specific MAC address.
To configure static DHCP:
STEP 1 Select Networking > LAN > Static DHCP.
STEP 2 From the VLAN drop-down menu, select a VLAN number.
VLAN ID Numerical VLAN ID to assign to endpoints in the VLAN
membership. The number you enter must be between
2 to 4094. VLAN ID 1 is reserved for the default VLAN,
and is used for untagged frames received on the
interface.
Description A description that identifies the VLAN.
Inter-VLAN Routing Inter-VLAN routing is the capability to route traffic
between vlans. Check Disable to disable.
Port 1
Port 2
Port 3
Port 4 (Available only
on the RV134W)
You can associate VLANs on the device to the LAN
ports on the device. By default, all LAN ports belong to
VLAN1. You can edit these ports to associate them
with other VLANs. Select the outgoing frame type for
each port:
Untagged - The interface is an untagged member of
the VLAN. Frames of the VLAN are sent untagged to
the port VLAN.
Tagge d - The port is a tagged member of the VLAN.
Frames of the VLAN are sent tagged to the port VLAN.
Excluded - The port is currently not a member of the
VLAN. This is the default for all the ports when the
VLAN is first created.
To Next Page
Loading...
