Cisco RV132W - Configuring LAN Connections

Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide 52
3
Configuring LAN Connections
The local device management IP address of the device is static and defaults to
192.168.1.1.
To change the local device management IP address:
STEP 1 Select Networking > LAN > LAN Configuration.
STEP 2 In the Network section, enter this information
STEP 3 In the IPv4 section, enter this information:
STEP 4 In the Server Settings (DHCP), in the DHCP Server field, select one of the
following options:
If you enabled the device DHCP server, enter this information:
Host Name Host name
Domain Name Domain name
VLAN The VLAN number.
Local IP Address Local LAN IP address of the device. Make sure this
IP address is not used by another device.
Subnet mask Subnet mask for the local IP address. The default
subnet mask is 255.255.255.0.
Enable Allows the device to act as the DHCP server in the network.
Disable Disables DHCP on the device when you want to manually
configure the IP addresses of all of your network devices.
DHCP Relay Relays the IP addresses assigned by another DHCP server to
the network devices.
Default Gateway IP
Address
The default gateway IP address is the gateway IP
address assigned to the DHCP client.
Start IP Address The first address in the IP address pool. Any DHCP
client joining the LAN is assigned an IP address in
this range.