Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide 51
3
STEP 4 In the Failover Check Interval field, enter the frequency (in seconds) with which the
device must attempt to detect the physical connection or presence of traffic on
the mobile network link. If the link is idle, the device attempts to ping a destination
at this interval. If there is no reply to the ping packet, the device assumes the link is
down and retries the Ethernet WAN interface.
STEP 5 In the Recovery Check Interval field, enter the frequency (in seconds) with which
the device must attempt to detect the physical connection or presence of traffic
on the Ethernet WAN link. If the link is idle, the device attempts to ping a
destination at the interval. If there is a reply to the ping packet, the device assumes
the link is up and attempts to disable the mobile network link and enable the
Ethernet WAN link.
STEP 6 Click Switch back to Ethernet immediately when Ethernet is available or click
Switch back to Ethernet in a specific time range and enter the start and end time
for the range.
STEP 7 In the Connection Validation Site field, choose the site from which to perform
failover validation. Use the next hop gateway (by default the device pings the
default gateway) or choose a custom site and enter the site IPv4 or IPv6 address.
STEP 8 Click Save to save your settings.
The WAN Interface table shows the status of the Ethernet WAN and mobile
network link to the Internet. Click the Status hyper link to view the port detail.
LAN Configuration
The default DHCP and TCP/IP settings work for most applications. If you want
another PC on your network to be the DHCP server, or if you want to configure
manually the network settings of all of your devices, disable DHCP.
Also, instead of using a DNS server that maps Internet domain names (for example,
www.cisco.com) to IP addresses, you can use a Windows Internet Naming Service
(WINS) server. A WINS server is the equivalent of a DNS server but uses the
NetBIOS protocol to resolve hostnames. The device includes the IP address of the
WINS server in the DHCP configuration the device sends to DHCP clients.
To Next Page
Loading...
