Access Control
Configuring ACL Binding
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x 247
17
STEP 4 To bind the ACLs to an interface, select the desired interface, and click Edit.
STEP 5 Select one of the following:
• Select MAC-Based ACL—Select a MAC-based ACL to be bound to the
interface.
• Select IPv4-Based ACL—Select an IPv4-based ACL to be bound to the
interface.
• Select IPv6-Based ACL—Select an IPv6-based ACL to be bound to the
interface.
STEP 6 Click Apply. The ACL binding setting is modified, and the Running Configuration is
updated.
NOTE If no ACL is selected, the ACLs that are previously bound to the interface are
unbound.
To Next Page
Loading...
Need help?
General
