Administration: Stack Management
Stack Topology
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 120
8
Stack in Ring Topology (550 family)
A ring topology is more reliable than a chain topology. The failure of one link in a ring does
not affect the function of the stack, whereas the failure of one link in a chain connection might
cause the stack to be split.
Topology Discovery
A stack is established by a process called topology discovery. This process is triggered by a
change in the up/down status of a stack port.
The following are examples of events that trigger this process:
• Changing the stack topology from a ring to a chain
• Merging two stacks into a single stack
• Splitting the stack
• Inserting other slave units to the stack, for instance because the units previously
disconnected from the stack due to a failure. This can happen in a chain topology if a
unit in the middle of the stack fails.
During topology discovery, each unit in a stack exchanges packets, which contain topology
information.
After the topology discovery process is completed, each unit contains the stack mapping
information of all units in the stack.
To Next Page
Loading...
Need help?
General
