Name: Cisco SF350-24P
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Quick Getting Started

Configuring Your Switch Using the Console Port

18 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4

The Getting Started page opens. You are now ready to configure the switch. Refer to the

Administration Guide or see the help pages for further information.

Browser Restrictions

If you are using IPv6 interfaces on your management station, use the IPv6 global address and

not the IPv6 link local address to access the device from your browser.

Configuring Your Switch Using the Console Port

To configure the switch using the console port:

STEP 1 Connect a computer to the switch console port using the supplied console cable.

STEP 2 Start a console port utility such as HyperTerminal on the computer.

STEP 3 Configure the utility with the following parameters:

• 115200 bits per second

• 8 data bits

• no parity

• 1 stop bit

• no flow control

STEP 4 Enter a username and password. The default username is cisco, and the default password is

cisco. Usernames and passwords are both case sensitive.

If this is the first time that you have logged on with the default username and password, the

following message appears:

Please change your password from the default settings. Please change the

password for better protection of your network. Do you want to change the

password (Y/N) [Y]?

STEP 5 Enter Y, and set a new administrator password.

NOTE Password complexity is enabled by default. The password must comply with the

default complexity rules.

Other manuals for Cisco SF350-24P

Questions and Answers:

Need help?

Do you have a question about the Cisco SF350-24P and is the answer not in the manual?

General