EasyManuals Logo

Cisco SF350-24P Administration Guide

Cisco SF350-24P
762 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #352 background imageLoading...
Page #352 background image
Multicast
IPv4 Multicast Configuration
270 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
15
STEP 8 For each interface, select its association type. The options are as follows:
Static—Attaches the interface to the Multicast group as a static member.
Dynamic—Attaches the interface to the Multicast group as a dynamic member.
Forbidden—Specifies that this port is forbidden from joining this group on this VLAN.
None—Indicates that the port is not currently a member of this Multicast group on this
VLAN. This is selected by default until Static or Forbidden is selected.
STEP 9 Click Apply. The Running Configuration file is updated.
IPv4 Multicast Configuration
The following pages configure IPv4 Multicast Configuration:
IGMP Snooping
IGMP Interface Settings
IGMP VLAN Settings
•IGMP Proxy
IGMP Snooping
To support selective IPv4 Multicast forwarding, bridge Multicast filtering must be enabled (in
the Properties page), and IGMP Snooping must be enabled globally and for each relevant
VLAN in the IGMP Snooping page.

Table of Contents

Other manuals for Cisco SF350-24P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SF350-24P and is the answer not in the manual?

Cisco SF350-24P Specifications

General IconGeneral
ModelSF350-24P
CategorySwitch
PoE Budget195W
LayerLayer 3
Power SupplyInternal
Uplink Ports2 x combo Gigabit SFP + 2 x Gigabit
MAC Address Table Size16K entries
Jumbo Frame Support9216 bytes
ManagementWeb, CLI, SNMP
FeaturesQoS, VLAN, IPv6, ACLs
Dimensions440 mm x 257 mm x 44 mm
Operating Temperature0°C to 45°C
Operating Humidity10% to 90% non-condensing
Weight3.48 kg

Related product manuals