IP Configuration
IPv4 Management and Interfaces
288 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
16
IPv4 Forwarding Table
To view the IPv4 Forwarding Table:
STEP 1 Click IP Configuration > IPv4 Management and Interfaces > IPv4 Forwarding Table.
The IPv4 Forwarding Table is displayed. The following fields are displayed for each entry:
• Destination IP Prefix—Destination IP address prefix.
• Prefix Length— IP route prefix for the length of the destination IP.
• Route Type—Whether the route is a local, reject or remote route.
• Next Hop Router IP Address—The next hop IP address.
• Route Owner—This can be one of the following options:
- Default—Route was configured by default system configuration.
- Static—Route was manually created.
- Dynamic—Route was created by an IP routing protocol.
- DHCP—Route was received from a DHCP server.
- Directly Connected—Route is a subnet to which the device is connected.
• Metric—Cost of this hop (a lower value is preferred).
• Administrative Distance—The administrative distance to the next hop (a lower value
is preferred). This is not relevant for static routes.
• Outgoing Interface—Outgoing interface for this route.
RIPv2
See IP Configuration: RIPv2.
VRRP
See IP Configuration: VRRP
To Next Page
Loading...
Need help?
General
