IP Configuration
IPv4 Management and Interfaces
310 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
16
• File Server Host Name (sname/Option 66)—Enter the name of the TFTP/SCP server.
• Configuration File Name (file/Option 67)—Enter the name of the file that is used as
a configuration file.
STEP 3 Click Apply. The Running Configuration file is updated.
DHCP Options
When the device is acting as a DHCP server, the DHCP options can be configured using the
HEX option. A description of these options can be found in RFC2131.
The configuration of these options determines the reply that is sent to DHCP clients whose
packets include a request (using option 55) for the configured DHCP options.
Example: The DHCP option 66 is configured with the name of a TFTP server in the DHCP
Options page. When a client DHCP packet is received containing option 66, the TFTP server
is returned as the value of option 66.
To configure one or more DHCP options:
STEP 1 Click IP Configuration > IPv4 Management and Interfaces > DHCP Server > DHCP
Options.
The previously-configured DHCP options are displayed.
STEP 2 To configure an option that has not been configured yet, enter the field:
• DHCP Server Pool Name equals to—Select one of the pool of network addresses
defined in the Network Pool page.
STEP 3 Click Add and enter the fields:
• Pool Name—Displays the name of the pool name for which code is being defined.
• Code—Enter the DHCP option code.
• Type—The radio buttons for this field, change according to the type of the DHCP
option’s parameter. Select one of the following codes and enter the value for the DHCP
options parameter:
- Hex—Select if you want to enter the hex value of the parameter for the DHCP
option. A hex value can be provided in place of any other type of value. For instance,
you can provide a hex value of an IP address instead of the IP address itself.
To Next Page
Loading...
Need help?
General
