Security: Secure Sensitive Data Management
SSD Rules
364 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
19
NOTE A device may not support all the channels defined by SSD.
Elements of an SSD Rule
An SSD rule includes the following elements:
• User type—The user types supported in order of most preference to least preference
are as follows: (If a user matches multiple SSD rules, the rule with the most preference
User Type will be applied).
- Specific—The rule applies to a specific user.
- Default User (cisco)—The rule applies to the default user (cisco).
- Level 15—The rule applies to users with privilege level 15.
- All—The rule applies to all users.
• User Name—If user type is Specific, a user name is required.
• Channel—Type of SSD management channel to which the rule is applied. The
channel types supported are:
- Secure—Specifies the rule applies only to secure channels. Depending on the
device, it may support some or all of the following secure channels:
Console port interface, SCP, SSH, and HTTPS.
- Insecure—Specifies that this rule applies only to insecure channels. Depending on
the device, it may support some or all of the following insecure channels:
Telnet, TFTP, and HTTP.
- Secure XML SNMP—Specifies that this rule applies only to XML over HTTPS
or SNMPv3 with privacy. A device may or may not support all of the secure XML
and SNMP channels.
- Insecure XML SNMP—Specifies that this rule applies only to XML over HTTP
or SNMPv1/v2 and SNMPv3 without privacy. A device may or may not support all
of the secure XML and SNMP channels.
• Read Permission—The read permissions associate with the rules. These can be the
following:
- (Lowest) Exclude—Users are not permitted to access sensitive data in any form.
- (Middle) Encrypted Only—Users are permitted to access sensitive data as
encrypted only.
To Next Page
Loading...
Need help?
General
