Access Control
ACL Binding
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 411
22
• IPv6 ACL—ACLs of type IPv6 that are bound to the interface (if any).
• Default Action—Action of the ACL’s rules (drop any/permit any).
NOTE To unbind all ACLs from an interface, select the interface, and click Clear.
STEP 4 Select an interface, and click Edit.
STEP 5 Enter the following for input and output ACLs:
Input ACL
• MAC-Based ACL—Select a MAC-based ACL to be bound to the interface.
• IPv4-Based ACL—Select an IPv4-based ACL to be bound to the interface.
• IPv6-Based ACL—Select an IPv6-based ACL to be bound to the interface.
• Default Action—Select one of the following options:
- Deny Any—If packet does not match an ACL, it is denied (dropped).
- Permit Any—If packet does not match an ACL, it is permitted (forwarded).
NOTE Default Action can be defined only if IP Source Guard is not activated on the
interface.
Output ACL
• MAC-Based ACL—Select a MAC-based ACL to be bound to the interface.
• IPv4-Based ACL—Select an IPv4-based ACL to be bound to the interface.
• IPv6-Based ACL—Select an IPv6-based ACL to be bound to the interface.
• Default Action—Select one of the following options:
- Deny Any—If packet does not match an ACL, it is denied (dropped).
- Permit Any—If packet does not match an ACL, it is permitted (forwarded).
NOTE Default Action can be defined only if IP Source Guard is not activated on the
interface.
STEP 6 Click Apply. The ACL binding is modified, and the Running Configuration file is updated.
NOTE If no ACL is selected, the ACL(s) that is previously bound to the interface are unbound.
To Next Page
Loading...
Need help?
General
