Cisco SF350-24P Administration Guide

Smart Network Application (SNA)
Tags
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 501
25
Built-In Tags
These tags are applied automatically to nodes as they are added to the topology. These tags can
be persistent or state-based. As long as the tag applies to the device, it cannot be removed from
the device. The following is a list of built-in tags:
View Tags
To view a list of all Tags, perform the following:
STEP 1 Click the Hamburger menu in the left-hand side of the Topology view:
Tags Method for Assigning Tag
SNA According to SNA internal data
Partial SNA According to SNA internal data
Offline According to SNA internal data
Switch According to advertised data on discovery protocols
Router According to advertised data on discovery protocols
Access Point According to advertised data on discovery protocols
IP Phone According to advertised data on discovery protocols
PC According to advertised data on discovery protocols (host)
Notifications According to SNA internal data. State based, is displayed if unread
notifications exist on the device.
PoE PSE According to SNA internal data – displayed if a device is capable of
supplying power via PoE (even if it doesn't actually supply any
power)
PoE PD According to SNA internal data. This is displayed if a device is
capable of receiving power via PoE (even if it does not actually
receive any power via PoE).

Cisco SF350-24P Specifications

General

Model	SF350-24P
Category	Switch
PoE Budget	195W
Layer	Layer 3
Power Supply	Internal
Uplink Ports	2 x combo Gigabit SFP + 2 x Gigabit
MAC Address Table Size	16K entries
Jumbo Frame Support	9216 bytes
Management	Web, CLI, SNMP
Features	QoS, VLAN, IPv6, ACLs
Dimensions	440 mm x 257 mm x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% non-condensing
Weight	3.48 kg