Smart Network Application (SNA)
Services
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 533
25
The selection of VLANs is from a list where all present VLANs on the network can be
selected. If the VLAN does not exist on a device to which a selected interface belongs, this
VLAN will be created as part of the service operation.
The user can also select an option to add a VLAN (1-4094). This VLAN will be added to all
switches that have interfaces that were selected for the service.
Interface Settings
This service configures basic interface settings for ports or LAGs.
Display Parameters
• Administrative Status—Up/Down.
• Current Status—Up/Down/Suspended. If the port is suspended, the suspension reason
is shown in parenthesis. For example: "Suspended (ACL)".
• Auto Negotiation—Enabled/Disabled
• Administrative Speed—This parameter is only displayed if Auto Negotiation is
disabled.
The values can be 10M, 100M, 1000M, 2500M, 5G, or 10G.
• Current Speed—10M, 100M, 1000M, 2500M, 5G, or 10G.
• Administrative Duplex Mode—This parameter is only displayed if Auto Negotiation is
disabled.
The values can be Half or Full.
• Current Duplex Mode—Half or Full.
Editable Parameters
• Administrative Status—Up/Down.
• Auto Negotiation—Enabled/Disabled.
• Speed—This parameter is only available for editing if Auto Negotiation is disabled.
The possible values for speed are: 10M, 100M, 1000M, 2500M, 5G, or 10G. Different
types of ports are capable of different subsets of these values, and the options displayed
in the service depend on the types of ports currently selected.
• Duplex Mode—This parameter is only available if Auto Negotiation is disabled and if
the selected speed is 10M or 100M.
To Next Page
Loading...
Need help?
General
