Cisco SNS 3400 Series - Page 33

It is not recommended to attempt offline installation of Cisco ISE as this can lead to system instability. When
you run the Cisco ISE installation script offline, the following error is shown:
Sync with NTP server failed' Incorrect time could render the system unusable until it is re-installed.
Retry? Y/N [Y]:
Choose Yes to continue with the installation. Choose No to retry syncing with the NTP server.
It is recommended to establish network connectivity with both the NTP server and the DNS server while
running the installation script.
Note
To run the setup program:
Step 1 Turn on the appliance that is designated for the installation.
The setup prompt appears:
Please type ‘setup’ to configure the appliance
localhost login:
Step 2 At the login prompt, enter setup and press Enter.
The console displays a set of parameters. You must enter the parameter values as described in the table that follows.
Table 1: Cisco ISE Setup Program Parameters
ExampleDescriptionPrompt
isebeta1Must not exceed 15 characters. Valid
characters include alphanumerical
(A–Z, a–z, 0–9), and the hyphen (-).
The first character must be a letter.
We recommend that you use
lowercase letters to ensure
that certificate
authentication in Cisco ISE
is not impacted by minor
differences in
certificate-driven
verifications. You cannot
use "localhost" as hostname
for a node.
Note
Hostname
10.12.13.14Must be a valid IPv4 address for the
Gigabit Ethernet 0 (eth0) interface.
(eth0) Ethernet interface address
255.255.255.0Must be a valid IPv4netmask.Netmask
Must be a valid IPv4 address for the
default gateway.
Default gateway
Install Cisco ISE Software on Cisco SNS Appliances
33
Install Cisco ISE Software on Cisco SNS Appliances
Run the Setup Program