Installing or Replacing an AC Power Supply
Procedure
Step 1 Turn off the power at its source.
Step 2 Remove the power cord from the power cord retainer.
Step 3 Remove the power cord from the power connector.
Step 4 Press the release latch at the right side of the power supply module inward and slide the power supply out.
Do not leave the power-supply slot open for more than 90 seconds while the switch is operating.
Caution
This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Warning
Step 5 Insert the new power supply into the power-supply slot, and gently push it into the slot. When correctly
inserted, the 350-W and 715-W power supplies (excluding the power cord retainer) are flush with the switch
rear panel. The 1100-W power-supply module extends 1.5 inches from the switch rear panel.
Figure 50: Inserting the AC-Power Supply in the Catalyst WS-C3850 Switch
Figure 51: Inserting the AC-Power Supply in the Catalyst WS-C3850-48XS Switch
Step 6 (Optional) Make a loop in the power cord and thread it through the power cord retainer.
Catalyst 3850 Switch Hardware Installation Guide
OL-26779-0574
Power Supply Installation
Installing or Replacing an AC Power Supply
To Next Page
Loading...
Need help?
General