3-5
Cisco VG202 and Cisco VG204 Voice Gateways Hardware Installation Guide
OL-15959-01
Chapter 3 Installing Cisco VG202 and Cisco VG204 Voice Gateways
Wall-Mounting the Chassis
• Power cord, 6 feet (1.8-meters long)
• RJ-45-to-DB-25 adapter cable (labeled Console)
• Grounding lug and fasteners
Inspect all items for shipping damage. If anything appears damaged, or if you encounter problems when
installing or configuring your system, contact a customer service representative. (See the
“Obtaining
Documentation and Submitting a Service Request” section on page xvi.)
Wall-Mounting the Chassis
The following warning applies only when the unit is wall-mounted:
Warning
This unit is intended to be mounted on a wall. Please read the wall-mounting instructions carefully
before beginning installation. Failure to use the correct hardware or to follow the correct procedures
could result in a hazardous situation to people and damage to the system.
Statement 248
You can mount the voice gateway on a wall or other vertical surface by using the molded
mounting-screw slots on the bottom of the voice gateway and two number-six, 3/4 inch (M3.5 x 20 mm)
screws. You must provide the screws.
Figure 3-2 shows the mounting-screw slots.
Figure 3-2 Mounting-Screw Slots for Wall-Mounting a VG202 or VG204 Voice Gateway
The following conditions must be met when you mount the voice gateway:
• Because you will use the LEDs as status and problem indicators, the LEDs on the front panel must
face upward and must be easily visible.
• The back panel must face downward to reduce strain on the cable connections.
1 Rubber feet 2 Mounting-screw slots
231984
1
1
1
1
2
2
To Next Page
Loading...
