About this Guide
Objectives
viii
Cisco VG248 Analog Phone Gateway Hardware Installation Guide
78-13154-01
Warning
Only trained and qualified personnel should be allowed to install,
replace, or service this equipment.
Objectives
This guide provides the required steps to install the VG248. You must use this
guide in conjunction with the Cisco VG248 Analog Phone Gateway Software
Configuration Guide to get the VG248 up and running on your network.
Because of the complexity of an IP telephony network, this guide does not provide
detailed information for required procedures performed on other Cisco or
third-party devices. Refer to the documentation provided with these systems for
installation and configuration instructions.
Organization
Table 1 provides an overview of the organization of this guide.
Table 1 Cisco Digital PBX Adapter 7630 Administration Guide Organization
Chapter Description
Chapter 1, “Overview” Provides overview of the hardware features and
technical specifications of the VG248.
Chapter 2, “Preparing to Install the VG248” Provides information about preparing the site for
installation, required tools, and safety
information.
Chapter 3, “Installing the VG248” Describes the steps required to properly and safely
install and configure the VG248 in your network.
Appendix A, “Regulatory Compliance and
Technical Specifications”
Provides regulatory compliance and technical
specifications for the VG248.
Appendix B, “Translated Safety Warnings” Provides translations of safety warnings used in
this guide.
To Next Page
Loading...
Need help?
General