Configuring the WAP4410N Wireless-N Access Point
Wireless
WAP4410N Wireless-N Access Point with Power Over Internet 29
6
Configuring WAP-Personal Security
Wi-Fi Protected Access (WPA) Personal (WAP-Personal) is a security standard
stronger than WEP encryption and forward compatible with IEEE 802.11e. WPA-
Personal is also known as WAP-PSK.
To enable wireless WPA-Personal security, follow these steps:
STEP 1 Click Wireless > Security.
STEP 2 From the Security Mode drop-down menu, select WAP-Personal.
STEP 3 To enable wireless isolation within the SSID, click Enabled.
STEP 4 Provide the following information:
• WPA Algorithms—WPA offers you two encryption methods, TKIP and AES
for data encryption. Select the type of algorithm you want to use, TKIP or
AES. The default is TKIP.
• Pre-Shared Key—Enter a WPA Shared Key of 8–63 characters.
• Key Renewal— Enter a key renewal timeout period, which instructs the
access point how often it should change the encryption keys. The default is
3600 seconds.
STEP 5 Click Save.
To Next Page
Loading...
