Configuring the WAP4410N Wireless-N Access Point
Wireless
WAP4410N Wireless-N Access Point with Power Over Internet 30
6
Configuring WAP2-Personal Security
This security mode supports the WPA2-Personal protocol.
To enable wireless WPA2-Personal security, follow these steps:
STEP 1 Click Wireless > Security.
STEP 2 From the Security Mode drop-down menu, select WAP2-Personal.
STEP 3 To enable wireless isolation within the SSID, click Enabled.
STEP 4 Provide the following information:
• WPA Algorithms—(Read-only) WPA2-Personal automatically chooses AES
for data encryption.
• Pre-Shared Key—Enter a WPA Shared Key of 8–63 characters.
• Key Renewal—Enter a key renewal timeout period, which instructs the
access point how often it should change the encryption keys. The default is
3600 seconds.
STEP 5 Click Save.
To Next Page
Loading...
