1-12
Catalyst 3560 Switch Hardware Installation Guide
OL-6337-07
Chapter 1 Product Overview
Front Panel Description
RPS LED
Note The Catalyst 3560-8PC and Catalyst 3560-12PC-S switches do not have an RPS LED.
For more information about the Cisco RPS 2300 and the RPS 675, see the Cisco Redundant Power
System 2300 Hardware Installation Guide and the Cisco RPS 675 Redundant Power System Hardware
Installation Guide.
Ta b l e 1- 3 R P S L E D
Color RPS Status
Off RPS is off or not properly connected.
Green RPS is connected and ready to provide back-up power, if required.
Blinking green RPS is connected but is unavailable because it is providing power to another device
(redundancy has been allocated to a neighboring device).
Amber The RPS is in standby mode or in a fault condition. Press the Standby/Active button
on the RPS, and the LED should turn green. If it does not, the RPS fan might have
failed. Contact Cisco.
Blinking amber The internal power supply in a switch has failed, and the RPS is providing power
to the switch (redundancy has been allocated to this device).
To Next Page
Loading...
