2-3. Operation Panel
CLP-621 & CLP-631 2-36 2-36
2-3-2. Operation using the keys 2-3-2. Operation using the keys
The following explains the normal operation and test operation accessible by pressing and holding
the keys while turning ON the power.
The following explains the normal operation and test operation accessible by pressing and holding
the keys while turning ON the power.
In this manual, pressing and holding the key while turning the power ON is described as follows: In this manual, pressing and holding the key while turning the power ON is described as follows:
+
[POWER]
+
[Key name] [Key name]
Example: [MODE] + [POWER] (to enter menu setting mode) Example: [MODE] + [POWER] (to enter menu setting mode)
(1) Normal operation (1) Normal operation
The following two operations are available. The following two operations are available.
Operation Description Remarks
[PAUSE] + [FEED] + [STOP]
+ [POWER]
Enters sensor adjustment
mode.
See (1-1). For details, see
the User's Manual.
[MODE] + [POWER] Enters menu setting mode.
See (1-2). For details, see
the User's Manual.
(1-1) Sensor adjustment mode
According to media to be used, you need to perform the sensor adjustment.
The following shows the rough description how to adjust the sensor. For details, refer to
the User’s manual.
Before performing the sensor adjustment, select the Media Sensor menu (“See Through”,
“Reflect”, or “None”) according to media to be used. See (1-2) “Menu setting mode” on the
next page.
Media Sensor menu Media
See Through Label paper or tag with U-shaped notches
Reflect Tag with black marks
None Continuous media
All operations are made with the key.
1. Entering the sensor adjustment mode ([PAUSE] + [FEED] + [STOP] + [POWER])
2. Selecting the sensor to be used (either the transparent sensor or reflective sensor)
Transparent sensor: Label paper, Tag with U-shaped notches
Reflective sensor: Tag with black marks
3. Positioning of the sensor(s) against media
4. Sensitivity adjustment using actual media to be used