2-3. Operation Panel
CLP-621 & CLP-631 2-44
(3-3) Factory/Service Mode menu table
The following table shows the value and description of each submenu under Factory Mode
menu and Service Mode menu.
(a) Factory Mode menu table
*: “+” shows that the object logically moves forward/rightward. “-“ shows that the
object logically moves backward/leftward.
**: For both CLP-621 and CLP-631, 8 dots correspond to 1 mm for each adjustment value.
(Namely, 203 dots correspond to 1”.)
Submenu Name
Adjustable Value
(Default Value)
Description
Through Sensor
Position
(See Note
1.)
-256 to +256 [dots]
(
+000 [dots])
Logically shifts the transparent sensor position
back and forth. (-32 to +32 mm, -1.26 to +1.26”)
Reflect Sensor
Position
(See Note 1.)
-256 to +256 [dots]
(
+000 [dots])
Logically shifts the reflective sensor position back
and forth. (-32 to +32 mm, -1.26 to +1.26”)
Machine Tear
Position
-256 to +256 [dots]
(
+000 [dots])
Logically shifts the tear off position back and forth.
(-32 to +32 mm, -1.26 to +1.26”)
Machine Cut
Position
-256 to +256 [dots]
(
+000 [dots])
Logically shifts the cutting position back and forth.
(-32 to +32 mm, -1.26 to +1.26”) (Optional)
Machine Peel
Position
-256 to +256 [dots]
(
+000 [dots])
Logically shifts the peel position back and forth.
(-32 to +32 mm, -1.26 to +1.26”) (Optional)
Machine
Horizontal Pos.
-16 to +32 [dots]
(
+08 [dots])
Logically shifts the head position to the right or left
side.
(-2 to +4 mm, -0.08 to +0.16”)
AutoCal Mode ON, OFF
(
ON)
Automatically controls the light amount in each
Media sensor menu (See Through, Reflect, None).
See Through
Sensor
0.0 to 3.3 [V]
(
0.0 [V])
This menu is effective when “AutoCal Mode” is set
to OFF. The light amount in Media sensor menu
“See Through” can be changed manually.
Larger value emits larger amount of light.
Reflect Sensor 0.0 to 3.3 [V]
(
0.0 [V])
This menu is effective when “AutoCal Mode” is set
to OFF. The light amount in Media Sensor menu
“Reflect” can be changed manually.
Larger value emits larger amount of light.
Note
1 :
“Through Sensor Position” adjustment and “Reflect Sensor Position” adjustment must be
done if one of the following parts is replaced.
• Main PCB Unit
• Transparent Sensor PCB SA
• Reflective Sensor PCB SA