2-3. Operation Panel
2-37 CLP-621 & CLP-631
(1-2) Menu setting mode (1-2) Menu setting mode
Set the menu according to your requirements. The following shows the menu settings print
sample. To enter this mode, while pressing and holding the [MODE] key, turn ON the
power. ([MODE] + [POWER]) For details, refer to the User’s Manual.
Set the menu according to your requirements. The following shows the menu settings print
sample. To enter this mode, while pressing and holding the [MODE] key, turn ON the
power. ([MODE] + [POWER]) For details, refer to the User’s Manual.
Machine Information Machine Information
Model Number : CLP-6XX Model Number : CLP-6XX
Boot Version : X.XX Boot Version : X.XX
ROM Version : XX00XXXX ROM Version : XX00XXXX
ROM Date(DD//MM//YY) : XX/XX/XX ROM Date(DD//MM//YY) : XX/XX/XX
ROMCheck Sum : XXXX ROMCheck Sum : XXXX
Head Check : OK Head Check : OK
Print Counter : 2.234 km Print Counter : 2.234 km
Service Counter : 2.234 km Service Counter : 2.234 km
Sensor Monitor : 1.50 V Sensor Monitor : 1.50 V
Option Interface : None Option Interface : None
Current Menu Settings Current Menu Settings
[Page Setup Menu] [Page Setup Menu]
Print Speed : 4 IPS Print Speed : 4 IPS
Print Darkness : 10 Print Darkness : 10
Darkness Adjust : 00 Darkness Adjust : 00
Print Method : Thermal Transfer Print Method : Thermal Transfer
Continuous Media Length :4.00 inch Continuous Media Length :4.00 inch
Vertical Position : 0.00 inch Vertical Position : 0.00 inch
Horizontal Shift : 0.00 inch Horizontal Shift : 0.00 inch
Media Sensor : See Through Media Sensor : See Through
Small Media Adjustment : Off Small Media Adjustment : Off
Small Media Length : 1.00 inch Small Media Length : 1.00 inch
* Symbol Set : PM * Symbol Set : PM
[System Setup Menu] [System Setup Menu]
Sensor Level : 1.5 V Sensor Level : 1.5 V
Buzzer Select : On Buzzer Select : On
Metric/Inch : Inch Metric/Inch : Inch
Max Media Length : 10.00 inch Max Media Length : 10.00 inch
Setting Lock : Off Setting Lock : Off
Keyboard Lock Off Keyboard Lock Off
Control Code : STD Control Code : STD
Emulation Select : DM4 Emulation Select : DM4
[After Print Menu] [After Print Menu]
AutoConfigure : On AutoConfigure : On
Function Select : Tear Function Select : Tear
Cutter Action : Backfeed Cutter Action : Backfeed
Paper Position : 0.00 inch Paper Position : 0.00 inch
Mode/Repeat Key : Disabled Mode/Repeat Key : Disabled
[Interface Menu] [Interface Menu]
RS-232C Baud rate : 9600 bps RS-232C Baud rate : 9600 bps
RS-232C Parity : None RS-232C Parity : None
RS-232C Length : 8 bit RS-232C Length : 8 bit
RS-232C Stop bit : 1 bit RS-232C Stop bit : 1 bit
RS-232C X-ON : Yes RS-232C X-ON : Yes
IEEE1284 : On IEEE1284 : On
* The settings of “Symbol
Set” can be changed only
b
a command.
Note: Citizen continually enhances its printers with new options and settings based on
our customer’s requests. Extra or changed menu items may appear on the print out in
some cases.
Note: Citizen continually enhances its printers with new options and settings based on
our customer’s requests. Extra or changed menu items may appear on the print out in
some cases.