Citizen MB Series - Registering Drying Procedures; Cooperation with Printer

- 19 -
11.2. Register procedure of drying
Moisture balance can work:
- independently
- cooperate with thermal printer (KAFKA 1/Z)
- cooperate with computer
If moisture balance works independently result appears on main
display. After measure moisture press key
switch over state of display from moisture measurement to mass
measurement. Display shows final mass of sample .
11.2.1. Cooperation with printer
During cooperation with thermal printer (KAFKA 1/Z) results of
moisture are printed in columns. Frequency of printing results from time of
resting samples. If time of testing samples is 5s sprinter will print singular
moisture results in ranges of 5 seconds.
Measurement lasts 8 minutes and time of testing samples 5 seconds, user
gets printout with u!ytk 96 measurements.
Final report is much shorter and more extented printout. After fihish drying
(when result of moisture is on display) attach KAFKA 1/Z printer, connect it
to moisture balance and press PRINT.