ENGINE
101
XSARA - XSARA PICASSOAUXILIARY EQUIPMENT DRIVE BELT
Engine : RHY
With air conditioning
B1BP1YLD
Tools
[1] Belt tension adjusting square : (-).0188 J2
[2] Ø 4 mm peg : (-).0188.Q1
[3] Ø 2 mm peg : (-).0188.Q2
[4] Dynamic tensioner compression lever : (-).0188.Z
REMOVAL
Re-used belt.
WARNING : Mark the direction the belt was fitted in case of re-use of the same belt.
- Compress the tensioner roller (7) by moving it at "c" (in anti-clockwise direction), tool [4].
- Hold the tensioner roller (7) compressed and remove the belt.
No re-use of belt.
- Compress the tensioner roller (7) by moving it at "c" (in anti-clockwise direction), tool [4].
- Peg using tool [2], at "d".
- Loosen the screw (6)
- Bring the eccentric roller (5) towards the rear.
- Tighten the screw (6) by hand.
- Remove the belt.
To Next Page
Loading...
