ENGINE
135
CHECKING AND SETTING THE VALVE TIMING
Engine : RHY
SETTING THE VALVE TIMING (continued).
- Retighten screws (9) by hand.
- Turn the pinion (12) (clockwise) to the bottom of the
buttonhole.
- Refit the belt on the crankshaft, in the following
order, using the tool [4] to keep the belt tight at "a".
- Guide roller (11).
- Fuel high pressure pump pinion (13).
- Camshaft pinion (12).
- Water pump pinion (10).
- Tensioner roller (6).
NOTE : If needed, slightly turn the pinion (12) anti-
clockwise (offset should not be more than one tooth).
- Remove the tool [4].
B1EP13FC
B1EP13GD
B1EP13ED
To Next Page
Loading...
