136
ENGINE
SETTING THE VALVE TIMING (continued).
- Position tool [1] on the belt at "b".
- Turn the roller (6) (anti-clockwise) using tool [2] to attain a tension of :
98 ± 2 SEEM units.
- Tighten screw (7) of the roller (6), tighten to 2.5 m.daN.
- Remove one screw (9) from the pinion (12).
(to check that the screws are not against the end of the buttonhole).
- Tighten the screws (9) to 2.m daN.
- Remove tools [1].[2].[3] and [5].
- Rotate the crankshaft 8 times (normal direction of rotation).
- Fit the tool [3].
- Loosen screws (9).
- Fit tool [5].
- Loosen screw (7) (to free the roller (6)).
- Fit tool [1].
- Turn the roller (6) (anti-clockwise), tool [2], to attain a tension of :
54 ± 2 SEEM units.
CHECKING AND SETTING THE VALVE TIMING
Engine : RHY
B1EP13HD
To Next Page
Loading...
