187
INJECTION
CHECKING AND SETTING THE DELPHI MECHANICAL INJECTION PUMP
Rep :
4093-T
1
2
3
4
5
Peg
Bracket
Dial gauge
Flat end
Relay lever
TOOLS
- Flywheel locating peg : 7014-T.J.Tool kit 7004-T
- Bracket and peg : 4093-T Tool kit 4123-T
B1HPOL6C B1HPON9C
Engines : DHY
CHECKING THE PUMP
- Peg engaged: The dial gauge should read "X" ± 0.03 engraved on the pump.
- If not, check the timing again.
SETTING THE PUMP
- Insert the peg (1) into the pump
- The peg must be against the guide tube "a". (If not, turn the engine backwards).
- Fit the tool 4093-T.
- Set the dial gauge to "0".
- When the dial gauge starts to move, it signifies that the piston is nearing TDC.
- Peg the flywheel.
- Slowly turn the pump toward the engine until measurement "X" can be seen.
("X" = Value engraved on each pump).
XSARA
To Next Page
Loading...
