CITROEN C2 - RADIO SOURCE; NOTES ON RADIO RECEPTION; SELECTION OF FREQUENCIES AND MEMORY BANKS; MANUAL SEARCH

131
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine: 9HX
B1EP18XC
Adjusting the timing belt tension.
Act on the tensioner roller (19) to align the marks «f» and «g», avoiding detensioning the timing belt,
using an allen spanner at «c».
Should this fail, repeat the operation to tension the timing belt.
Hold the tensioner roller (19).
Tighten the tensioner roller fixing nut to 3,7 ± 0,3 m.daN.
Check the position of the tensioner roller (the alignment of the marks «f» and «g» should be correct) .
Remove tools [2] and [3].
Rotate the crankshaft six times clockwise.
IMPERATIVE: Never rotate the engine backwards.
WARNING: Do not touch or damage the track of the target of the engine speed sensor (14).
Peg the crankshaft, using tool [3].
Check the position of the tensioner roller (the alignment of the marks «f» and «g» should be correct) .
If this is not the case, repeat the operation to tension the timing belt.
Peg the camshaft pulley, using tool [2].
C3
Angl.-T1-page 92-134-2005 9/01/06 9:16 Page 131